System features

The Matrix MP150 amplifier is a proprietary switching amplifier. It uses a unique pulse control scheme that takes feedback only from the speaker terminals. There is no feedback loop from the switching output used. The result is extremely low output impedance over the entire bandwidth.

Damping factor is >400 up to 2 kHz and >100 at 20 kHz. The frequency response is 1 Hz-50 kHz (+0,-3dB) and is completely independent of the load impedance.

THD and IMD are very low (<0.02%) and completely independent of frequency, like a good zero-feedback amplifier.

Technical specs

Type:	MAT-MP150-1.0
System:	Mono power amplifier Pulse Control Amplifier using Discrete transistors and FET's
RMS Power:	100 Watt at 8 Ohm 150 Watt at 4 Ohm
Frequency range:	1 - 50k Hz (= 0 dB , -3 dB)
Input sensitivity at max power:	1.2 Volt
Input current at 1/8 rated power:	160 mA at 230 Volt 320 mA at 115 Volt
Fuse:	5 x 20 mm, 3.15 mA, 250 V AC Time lag T
Total Harmonic Distortion (THD):	< 0..02
Inter-Modulation Distortion (IMD):	< 0..02
SNR:	120 dB
Input impedance:	220k Ohm XLR 110k Ohm RCA

Dimensions

The modest size of the MP150 is actual hiding the performance this Power amplifier can deliver.

Including Stand:
Width:	124 mm / 4.88 inch
Height:	59 mm / 2.32 inch
Depth:	250 mm / 9.84 inch
Excluding stand:
Width:	124 mm / 4.88 inch
Height:	52 mm / 2.05 inch
Depth:	250 mm / 9.84 inch

Advice

Advised pre-amplifier
It is recommended to combine the Matrix MP150 power amplifier with the Matrix P150 pre-power amplifiers. This combination of the Matrix amplifier and pre-amplifier is specially designed to match both musically as visually.  

Advised external cable
The Matrix MP150 can be perfectly complemented with the Matrix cable series .

A Kharma product must not only have an unbelievable refined sound, which meets the needs of a true music lover, but also must have an astonishing finish to compete with the musicality of the system.

Primary Stock Program
The originality of this Matrix amplifier consists of returning to the origin. This is reached by making the body of the amplifier almost completely out of aluminium.  Two finishes of this amplifier have proven their looks in the past and showing of this clear massage of returning to the origin. Therefore the available colour options in the primary stock program are blank and black anodized aluminium.  

* Colours shown only give an indication of the real colour, contact your dealer for references.